Press the Lipo battery with the wires pointed to the curved rear of the top platform into a spot near the middle of the underside of the top platform, away from screw posts. This tool can also be used as a wire crimper for 10 to 22AWG insulated terminals and 4 to 22AWG non-insulated terminals. It is also possible to use this method to passively measure the absolute displacement of the motor. Be careful not to pull on the camera cable! I tend to call them "clock" or "clk" and "data" so bear with me. Screw down the top platform with the 4 M3 screws. Displacement starts at 1 due to an inherent fencepost error.
We have a be nice policy. Pins 2 and 3 are ground for all of the sensors except the button which is just a switch. The new stripax r Pro 6 and Pro 16 perform powerful stripping of standard and industrial insulation for a wire range of AWG. Green terminal blocks that have a dual level style. Step 6 - Mount components on to the middle platform.
The USB connector may not be soldered onto the board ie 1st image. Be careful not to damage the camera. Every sensor has a 7 bit address which is sent in conjunction with a directional bit. Finger thread the M3 nuts into the screws, then use the screwdriver to tighten the nuts down to hold the wheel assembly in place. Mount it as close as possible to the middle of the top platform, marked by the arrow in the image. Here you'll select from the avialable options for this product colors, lengths, packages, quantities, etc.
From Bag F , grab 3 M3 screws and 6 M3 nuts. By watching the pattern, you can determine direction of rotation. Auto transformers are also allowed. Let me know if you'd like that. A must have for clipping leads and extra solder tails.